Modern Classics-Ring Design
( part 1 )
( part 1 )
In my writing the following, I will share about how to manufacture a ring-like image above
design / contained in Studio3-JewelCAD.
The steps are quite easy and not too difficult for you to learn or as an exercise for you to learn to use JewelCAD.
The step is:
1. Creating a curve to the size of the ring. (Inside diameter of the ring)
2. Make the curve to use to make the body of the ring.
3. Make the curve as a section. (Forming the surface of the body ring)
4. Make the curve as a place from the top of the stone settings.
5. Creating the next curve given surface to make the stone place on
the left and right side of the ring body.
Toolbar used are:
1. SURFACE RAIL: Two Rail - Single section - section extents. (Body ring)
2. OFFSET CURVE.
3. REVOLVE VERTICAL SURFACE. (Upper ring setting)
4. TAPER.
5. CUT & PASTE. (Placement Diamond / Cz)
6. DATABASE - materials.
Here is picture of the steps above :
Pic 1.
Pic 2.
Pic 3.
Pic 4.
Pic 5.
Pic 6.
Pic 7.
We Continue with the step ,how to made part of top for stone setting :
Pic 8.
Pic 9.
Pic 10.
Pic 11.
Pic 12.
Pic 13.
Pic 14.
Pic 15.
Pic 16.
Pic 17.
Pic 18.
Pic 19.
Pic 20.
Next we will enter into the step with how to arrangement stone/stone setting on ring surfaces.
We will continue in session " Modern Classic - Ring Design ( part 2 ) "
