Modern Classics Ring ( part 2 )

Modern Classics - Ring Design 

(part 2)

To continue my tutorial article about how to made the Modern Classics - Ring Design (Part 1),
in this section I will continue on "how to make the setting the stone on the surface of the ring".

Here are some pict for next steps:

Pic 21. 

 Pic 22. 

 Pic 23. 

 Pic 24. 

 Pic 25. 

 Pic 26. 

 Pic 27. 

Pic 28.  

Pic 29. 

Pic 30. 

Next step its put the prongs between the stone.

Prongs have a function to catch the stone.

For that step lets see the pic :

 Pic 31.

 Pic 32.

 Pic 33.

Pic 34.

 Pic 35.

 Pic 36.

 Pic 37.

 Pic 38.

 Pic 39.

 Pic 40.

 Pic 41.

Pic 42.

For the next learning we gonna change the default material ( Yellow Gold ) with our choice material
and we will see the transformation on your ring design.
For the step :

Pic 43.

Pic 44.

 Pic 45.

Pic 46.

We already make a transformation for the material,for the next step we gonna put the big stone ( 5.0mm )

in the middle side.

See the pic :

Pic 47.

Pic 48. 

Pic 49. 

Pic 50 

Pic 51. 

Pic 52.

Pic 53. 

Pic 54.

Until in this step ( part 1-2 ), I hope anyone whose learning about JewelCAD can understand 

about what I'm write.

For the next we will learn about " how to make a stone setting in the left - right side the ring".

See You on " Modern Classics Ring ( part 3  ) "

Have a Question and more information send email to :  

 studiotiga_3d@yahoo.com

  

Modern Classic Ring

Modern Classics-Ring Design
( part 1 )

In my writing the following, I will share about how to manufacture a ring-like image above
design / contained in Studio3-JewelCAD.
The steps are quite easy and not too difficult for you to learn or as an exercise for you to learn to use JewelCAD.

The step is:
1. Creating a curve to the size of the ring. (Inside diameter of the ring)
2. Make the curve to use to make the body of the ring.
3. Make the curve as a section. (Forming the surface of the body ring)
4. Make the curve as a place from the top of the stone settings.
5. Creating the next curve given surface to make the stone place on
     the left and right side of the ring body.

Toolbar used are:
1. SURFACE RAIL: Two Rail - Single section - section extents. (Body ring)
2. OFFSET CURVE.
3. REVOLVE VERTICAL SURFACE. (Upper ring setting)
4. TAPER.
5. CUT & PASTE. (Placement Diamond / Cz)
6. DATABASE - materials.

Here is picture of the steps above :

Pic 1.

Pic 2.

Pic 3.

Pic 4.

Pic 5.

Pic 6.

Pic 7.

We Continue with the step ,how to made part of top for stone setting :

 Pic 8.

 Pic 9.

 Pic 10.

Pic 11.

Pic 12.

 

 Pic 13.

 Pic 14.

Pic 15.

Pic 16.

Pic 17.

Pic 18.

Pic 19.

Pic 20.

Next we will enter into the step with how to arrangement stone/stone setting on ring surfaces.

We will continue in session " Modern Classic - Ring Design ( part 2 ) "